Zenith h27e44dt 操作ガイド
P A G E 9
Hook Up Over-The-Air Antenna and VCR
Connect your off-air antenna and VCR to the Presentation TV
No A/V cables are included with the Zenith
Presentation TV.
Presentation TV.
Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
videocassettes in stereo sound.
TV Back
S-Video
In
M.P.I.
R- Audio - L
In
S-Video
Out
Antenna
Cable
Video
In
Matrix
Out
R- Audio - L
In
In
Out
Audio
Video
3 4
VCR Back
VCR Back AV Panel
output
switch
Flat Wire
(300 ohm)
Antenna
300/75 ohm
Adapter
A/V cables
not included
with TV
TV Back
S-Video
In
M.P.I.
R- Audio - L
In
S-Video
Out
Antenna
Cable
Video
In
Matrix
Out
R- Audio - L
In
In
Out
Audio
Video
3 4
VCR Back
VCR Back AV Panel
output
switch
A/V cables
not included
with TV
RF Coaxial Wire
(75 ohm)
Antenna
Locate the Antenna/Cable (In) jack on the
back of the VCR.
back of the VCR.
Connect the cable that runs from the antenna
directly to this jack, according to one of the
diagrams shown to the right.
directly to this jack, according to one of the
diagrams shown to the right.
Remove the back of the remote and put in
two AAA batteries.
two AAA batteries.
Plug your TV in to a standard power outlet.
This TV is designed to operate on standard
current, 120-volt 60 Hertz AC. Do not attempt
to operate it on DC Current.
This TV is designed to operate on standard
current, 120-volt 60 Hertz AC. Do not attempt
to operate it on DC Current.
Go to page 14 to Auto Program the
Presentation TV.
Presentation TV.
1
2
3
4
5
back of
remote
206-3753