ZyXEL p-660h-61 ユーザーガイド
Prestige 660H Series User’s Guide
Remote Node Configuration
25-5
25.2.3 Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol possible. However,
some vendors’ implementation includes specific authentication protocol in the user profile. It will
disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If the peer disconnects right after a successful authentication, make
sure that you specify the correct authentication protocol when connecting to such an implementation.
some vendors’ implementation includes specific authentication protocol in the user profile. It will
disconnect if the negotiated protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If the peer disconnects right after a successful authentication, make
sure that you specify the correct authentication protocol when connecting to such an implementation.
25.3 Remote Node Network Layer Options
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Layer Options as shown next.
1.
In menu 11.1, make sure IP is among the protocols in the Route field.
2.
Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
Figure 25-3 Menu 11.3 Remote Node Network Layer Options
The next table explains fields in Menu 11.3
–
Remote Node Network Layer Options.
Table 25-2 Menu 11.3 Remote Node Network Layer Options
FIELD DESCRIPTION
EXAMPLE
IP Address
Assignment
Assignment
Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote node is
using a dynamically assigned IP address or Static if it is using a static (fixed) IP
address. You will only be able to configure this in the ISP node (also the one you
configure in menu 4), all other nodes are set to Static.
using a dynamically assigned IP address or Static if it is using a static (fixed) IP
address. You will only be able to configure this in the ISP node (also the one you
configure in menu 4), all other nodes are set to Static.
Dynamic
Rem IP Addr
This is the IP address you entered in the previous menu.
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment = Static Ethernet Addr Timeout(min)= N/A
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=
Enter here to CONFIRM or ESC to CANCEL:
IP Options: Bridge Options:
IP Address Assignment = Static Ethernet Addr Timeout(min)= N/A
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=
Enter here to CONFIRM or ESC to CANCEL: