ZyXEL p-2302hw-p1 ユーザーズマニュアル

P-2302HW/HWL-P1 Series User’s Guide

212

Chapter 17 Bandwidth MGMT

Figure 114   Management > Bandwidth MGMT > Summary

Each field is described in the following table.

Table 91   Management > Bandwidth MGMT > Summary

LAN

Active

Select this to enable bandwidth management on the LAN. Bandwidth management 
applies to all traffic flowing out of the router through the LAN, regardless of the 
traffic’s source.

Traffic redirect or IP alias may cause LAN-to-LAN traffic to pass through the ZyXEL 
Device and be managed by bandwidth management.

Speed

Enter the amount of bandwidth for this interface that you want to allocate using 
bandwidth management. 

The recommendation is to set this speed to match the interface’s actual 
transmission speed. For example, set the LAN interface speed to 10000 kbps if 
your Internet connection has an upstream transmission speed of 10 Mbps.

You can set this number higher than the interface’s actual transmission speed. 
This will stop lower priority traffic from being sent if higher priority traffic uses all of 
the actual bandwidth.

You can also set this number lower than the interface’s actual transmission speed. 
If you do not enable Maximize Bandwidth Usage, this will cause the ZyXEL 
Device to not use some of the interface’s available bandwidth.

This field is not affected by the 

Scheduler

Select Priority-Based to give preference to bandwidth classes with higher 
priorities. Select Fairness-Based to treat all bandwidth classes equally.

Maximize 
Bandwidth Usage

Select this if you want the ZyXEL Device to divide any unallocated and unused 
bandwidth among bandwidth classes that require bandwidth. Clear this if you want 
to reserve bandwidth for traffic that does not match a bandwidth class or if you 
want to limit the speed of this interface.