ZyXEL nbg-334w ユーザーガイド

Chapter 4 AP Mode

NBG334W User’s Guide

Table 24   Network > LAN > IP

   

  

The configuration of wireless and maintenance settings in AP Mode is the same as for Router 
Mode.

• See 

 for information on the configuring your wireless network.

• See 

 for information on the configuring your 

Maintenance settings. 

1 Connect your computer to the LAN port of the NBG334W. 
2 The default IP address if the NBG334W is “192.168.1.1”. In this case, your computer 

must have an IP address in the range between “192.168.1.2” and “192.168.1.255”.

3 Click Start > Run on your computer in Windows. 
4 Type “cmd” in the dialog box.
5 Type “ipconfig” to show your computer’s IP address. If your computer’s IP address is 

not in the correct range then see 

 for information on changing 

your computer’s IP address.

6 After you’ve set your computer’s IP address, open a web browser such as Internet 

Explorer and type “192.168.1.1” as the web address in your web browser.

See 

 for a tutorial on setting up a network with an AP.

Get form 

DHCP Server

Select this option to allow the NBG334W to obtain an IP address from a DHCP 

server on the network. You must connect the WAN port to a device with a DHCP 

server enabled (such as a router or gateway). Without a DHCP server the NBG334W 

will have no IP address. You need to find out the IP address the DHCP server 

assigns to the NBG334W and use that address to log in to the NBG334W again. 

User Defined 

LAN IP 

Select this option to set the NBG334W’s IP address. This setting is selected by 

default. Check the IP address is on the same domain as other devices on your 

network.

IP Address

Type the IP address in dotted decimal notation. The default setting is 192.168.1.1. If 

you change the IP address you will have to log in again with the new IP address.   

IP Subnet 

Mask

The subnet mask specifies the network number portion of an IP address. Your 

NBG334W will automatically calculate the subnet mask based on the IP address that 

you assign. Unless you are implementing subnetting, use the subnet mask computed 

by the NBG334W.

Gateway IP 

Address

Type the IP address of the gateway. The gateway is an immediate neighbor of your 

NBG334W that will forward the packet to the destination. In AP Mode, the gateway 

must be a router on the same segment as your NBG334W.

Apply

Click Apply to save your changes to the NBG334W.

Reset

Click Reset to reload the previous configuration for this screen.