Sharp MX-2300N クイック設定ガイド

CHANGING THE FILE FORMAT

The file format (file type and compression method) for sending a scanned image is specified when the destination
is stored in a one-touch key; however, you can change the format at the time of transmission.
The procedure below explains how to send a scanned image in full color TIFF format.

Place the original.

When using the document glass, place the original
with the side to be scanned face down.

Select format settings in the touch panel.

(1) Touch the [Image Settings] key.

(2) Touch the [File Format] key.

(3) Read the displayed message and touch

the [OK] key.

(4) Change the mode to Color/Grayscale

mode.

(5) Touch the [TIFF] key.

(6) Touch the [High] key.

This sets the compression to high.
A higher compression ratio creates a smaller file
size.

(7) Touch the [OK] key.

Select the destination and press the
[COLOR START] key.

If the file type is set to [Encrypt PDF], you will be
prompted to enter a password when you start
transmission.

The side to be scanned must be face up!

File Type

Compression Mode

Compression Ratio

Color/Gray

B/W

TIFF

PDF

Encrypt PDF

Programmed

Specified Pages per File

None

MH (G3)

(1-99)

MMR (G4)

File Type

Color/Gray

B/W

TIFF

JPEG

PDF

Encrypt PDF

Programmed

Specified Pages per File

Low

Medium

(1-99)

High

Quick File

File

Special Modes

Address Entry

Address Book

Scan

Mode Switch

Image

Settings

Send Settings

Auto

Exposure

200X200dpi

TIFF/JPEG

Mono2/Auto

Resolution

File Format

Color Mode

Original

Special Modes

Select a file format to apply it to
all scan destinations.

Auto 8 x11

(2)

(3)

(7)

(6)

(4)

(1)

(5)

Cancel scanning

mx4500_us_qck.book 61 ページ２００５年１１月１日　火曜日　午後４時４９分