Sharp MX-2300N ユーザーガイド

Network settings are described below. Touch the [Network Settings] key and configure the settings.

When using the machine on a TCP/IP network, use this 
setting to configure the IP address of the machine.

Make sure that the [DHCP] checkbox is not selected 

 

and then select each key, enter the required values with 
the numeric keys, and touch the [OK] key.
To set the machine to obtain an IP address 
automatically, select the [DHCP] checkbox 

and 

touch the [OK] key.

To use the machine on a TCP/IP network, this setting 
must be enabled. The IP address of the machine must 
also be configured using "

To enable this setting, select the checkbox 

 and 

touch the [OK] key.

To use the machine on a NetWare network, this setting 
must be enabled.
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

To use the machine on an EtherTalk network, this 
setting must be enabled.
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

To use the machine on a NetBEUI network, this setting 
must be enabled.
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

This returns all of the settings on the print server card to 
the factory default settings.

Use this function to check if the machine can 
communicate with a computer on the network.
Specify the IP address of the desired computer and 
touch the [Start] key. A message will appear indicating 
whether or not the computer responded.

Select each key, enter the appropriate values with the 
numeric keys, and touch the [Start] key.

When any of these settings are changed, you must exit the system settings, turn off the [POWER] key (

), wait a brief 

interval, and then turn the [POWER] key (

) back on to make the new settings take effect.

• To use the machine on a TCP/IP network, the 

"

" setting must also be enabled.

• If DHCP is used, the IP address assigned to the 

machine may change automatically. If the IP 
address changes, printing will not be possible.

System Settings

IP Address Setting

IP Address

IP Subnet Mask

IP Gateway

OK

DHCP

System Settings

Ping Command

Enter the IP Address and press [Start].

IP Address

Start

OK