Sharp MX-2300N ユーザーガイド

This setting is used to select when port switching takes 
place.

• Switch at End of Job:

The port changes to auto selection when printing 
ends.

• Switch after I/O Timeout:

When the time set in "

" (page 102) 

elapses, the port changes to auto selection.

Select one of the keys and touch the [OK] key.

This is used to adjust grayscale and color balance.
Touch [Printer Settings] key and touch the [Color Adjustments] key and configure the settings.

This is used to perform automatic color correction when 
the color in color copies is off. The machine prints a test 
patch, the test patch is scanned, and the color is 
automatically corrected.

After the [Execute] key is touched and a test patch is 
printed, a message appears prompting you to begin 
automatic calibration. Place the test patch on the 
document glass as shown below so that the narrow line 
of one-side of the paper is on the left and touch the 
[Execute] key.

Lay copy paper (about five sheets) that is the same size 
as the test patch on top of the placed test patch, and 
gently close the automatic document feeder.

The following two print ports are available on the 
machine:

• USB port

• Network port

System Settings

Auto Color Calibration

Use 11"x17" or A3 paper for this adjustment.
Press [Execute] to print the test patch.

OK

Execute

Narrow line

• Before executing Auto Color Calibration, check to 

see if the registration adjustment is correct. If the 
registration adjustment is not correct, perform 
"

" (page 95).

• If the color is still off after performing Auto Color 

Calibration, repeating Auto Color Calibration once 
again may improve the color.