Sharp MX-2300N ユーザーガイド

The subject, file name, reply-to, and message can be changed when performing a scan transmission. Preset items can 
be selected or text can be directly entered.

• When performing Scan to FTP, Scan to Desktop, or Scan to Network Folder, only the file name is used.

• If the subject and file name are not changed, the settings in the Web page are used.

• If the sender name is not changed, the name set in "Default Sender Set" in the system settings is used. If this is not 

configured, the administrator name in the Web pages is used.

• Selections for the subject, file name, and message are configured by clicking [Application Settings] and then [Network 

Scanner Settings] in the Web page menu. (Administrator rights are required.)

• For the procedure for entering text, see "6. ENTERING TEXT" in the User's Guide.

If you are sending to a Scan to FTP, Scan to Desktop, or Scan 
to Network Folder destination, go to step 4.

• If you wish to directly enter the text, touch the [Direct Entry] key to open the text entry screen. Enter the text and 

touch the [OK] key. Up to 54 characters can be entered.

• The text in a pre-set text key can be edited by touching the pre-set text key and then the [Direct Entry] key. The text 

entry screen will appear with the selected pre-set text entered. (When a destination is stored using the Web page, 
up to 80 characters can be entered. However, only 54 characters will appear and can be edited in the touch panel.)

Quick File

File

Special Modes

Address Entry

Resend

Scan

 8 x11

1 

/

 2

Send

Ready to send.

Address Book

Scan

Mode Switch

Image

Settings

Send Settings

 Auto

Send Settings

OK

Subject

File Name

Reply-To

Add 'Reply to' to Cc

Body Text

Pre-Set

OK

Cancel

1/5

Direct Entry

No.04

No.05

No.06

No.01 Sub: Schedule coordinat

No.02 Sub: Monthly Schedule

No.03 Sub: Minutes of plannin