Sharp MX-2300N ユーザーガイド

The staple function can be used to staple output.
This function saves considerable time when preparing materials such as handouts for a meeting. The staple function 
can also be used in combination with 2-sided printing to create materials with a more sophisticated appearance.
Stapling positions and the number of staples can be selected to obtain the following stapling results.

To punch holes in the output, click the [Punch] checkbox so that a checkmark 

 appears. Punch hole positions can be 

set using [Binding Edge].

• To use the staple function, a finisher or saddle stitch finisher is required.

• To use the punch function, a punch unit must be installed on the finisher or saddle stitch finisher.

• The number of holes that can be punched and the spacing between the holes varies depending on the installed punch 

module.

• The maximum number of sheets that can be stapled is as follows.

When a finisher is installed: 50 sheets (30 sheets for Foolscap, B4, or larger sizes)
When a saddle stitch finisher is installed: 30 sheets (25 sheets for Foolscap, B4, or larger sizes)

• The staple function and offset function cannot be used at the same time.

• When the finisher is disabled in the machine's system settings (administrator), the staple function and punch function 

cannot be used.

• When the staple function or the punch function is disabled in the machine's system settings (administrator), stapling or 

punching is not possible.

• For information on pamphlet stapling, see "

" (page 22).