Sharp MX-5500N 操作ガイド

• When using the bypass tray, place the paper with the print 

side down.
Place the paper so that the sides with the tabs enter the 
machine last. 
After loading the tab paper, configure the bypass tray 
settings as explained in "

" (page 41).

• If you are using tray 3, see "Loading tab paper" in the User's 

Guide. After loading tab paper in tray 3, select tray 3 as 
explained in "

The width of the tab paper can be as wide as 8-1/2" x 11" paper (8-1/2") plus 5/8" (or A4 width (210 mm) plus 20 mm).

Copying will begin.
If you are using the document glass to copy multiple original 
pages, copying will take place as you scan each original. If you 
have selected sort mode, change originals and press the 
[START] key. Repeat until all pages have been scanned and 
then touch the [Read-End] key. (For the second original and 
following originals, use the same [START] key as you did for 
the first original.)

To cancel scanning and copying...
Press the [STOP] key (

).

To cancel tab copy...
Touch the [Cancel] key in the screen of step 3.

System Settings (Administrator): Initial Tab Copy Setting
The default image shift width can be set from 0" to 5/8" (0 mm to 20 mm). The factory default setting is "1/2" (10 mm)".

Reverse side