Sharp MX-5500N 操作ガイド

This transfers output to the finisher or saddle stitch 
finisher.

These contain toner for printing. When the toner runs out 
in a cartridge, the cartridge of the color that ran out must 
be replaced.

☞

 (page 71)

Heat is applied here to fuse the transferred image onto 
the paper.

During full color printing, the toner images of each of the 
four colors on each of the photoconductive drums are 
combined together on the transfer belt. During black and 
white printing, only the black toner image is transferred 
onto the transfer belt.

Open this cover to operate the fusing unit pressure 
adjusting lever and to remove a misfeed.

☞

 (page 43)

This is used when 2-sided printing is performed. Open 
this cover to remove a paper misfeed.

Use this tray to feed paper manually.
When loading paper larger than 8-1/2" x 11"R or A4R, be 
sure to pull out the bypass tray extension.

☞

 (page 38)

This is used to power on the machine.
When using the fax or Internet fax functions, keep this 
switch in the "on" position.

☞

 (page 16)

This collects excess toner that remains after printing.

☞

 (page 74)

Open this to remove a paper misfeed from trays 1 to 4, or 
to replace the waste toner box.

To remove a paper misfeed, pull and hold this lever up to 
open the right side cover.

* Peripheral device.

When a finisher / 
saddle stitch finisher is 
not installed

Do not touch or damage the transfer belt. This may 
cause a defective image.

Your service technician will collect the waste toner 
box.