Sharp MX-5500N 操作ガイド

• When using plain paper other than SHARP standard paper or special media other than SHARP-recommended 

transparency film, or when printing on the reverse side of previously used paper, the paper must be loaded one sheet 
at a time. Loading more than one sheet at a time will cause misfeeds.

• Before loading paper, straighten any curling in the paper.
• When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and 

reload as a single stack. If paper is added without removing the remaining paper, a misfeed may result.

To print on tab paper, load tab paper in the bypass tray with the print side face down.

Place paper that is 7-1/4" x 10-1/2" (A5) or smaller in the horizontal 
orientation.

• Use only tab paper that is made of paper. Tab paper made of a material other than paper (film, etc.) cannot be used.

• To print on the tabs of tab paper...

In copy mode, use "Tab Copy" in the special modes. In print mode, use the tab print function. For more information on 
these functions, see the Copier Guide and the Printer Guide.

• Use SHARP-recommended transparency film. When inserting 

transparency film in the bypass tray, the rounded corner 
should be at the front left when the film is oriented horizontally, 
or at the far left when the film is oriented vertically.

• When loading multiple sheets of transparency film in the 

bypass tray, be sure to fan the sheets several times before 
loading.

• When printing on transparency film, be sure to remove each 

sheet as it exits the machine. Allowing sheets to stack in the 
output tray may result in curling.

Face down

Horizontally

Vertically