Sharp MX-M1100 操作ガイド

• System settings

Descriptions of system settings similar to the following example appear in this chapter. 
Example:
➞ System Settings (Administrator) > "Copy Settings" > "Other Settings" > "Rotation Copy Setting" > 
This is an abbreviated description of the procedure for selecting the setting. ">" indicates the setting sequence and 

 indicates the state of the setting after it has been enabled. Use these descriptions as a quick manual to help you 

configure the settings. (For detailed explanations of the system settings (Administrator), see the Administrator's 
Guide.)

• For problems common to all functions of the machine and peripheral devices, see this manual.

• If you are unable to solve a problem using the solutions in this chapter, switch off the [POWER] key (

) and the 

main power switch. Wait at least 10 seconds, and then switch on the main power switch and the [POWER] key (

) 

in that order.

* Do not turn off the machine's main power switch or remove the power plug while a job is being executed or 

processed. This may damage the hard drive or cause the data being stored or received to be lost.

• If you are unable to solve a problem using the information in this chapter, please contact your dealer or nearest 

SHARP Service Department.

Have functions been disabled by the 
administrator?

Some functions may have been disabled in the system 
settings (administrator). Check with your administrator.
When user authentication is enabled, the functions that 
you can use and page counts may be restricted in your 
user settings. Check with your administrator.

Is the main power indicator lit?

If the main power indicator is not lit, make sure that the 
power plug is firmly inserted in the power outlet, switch 
the main power switch to the "on" position. Hold down 
the [POWER] key (

) and turn on the power.

☞

 (page 18)

Did you just power on the machine?

After the [POWER] key (

) is turned on, the machine 

requires some time to complete warmup operation.
During this time functions can be selected, however, a 
job cannot be run. Wait until a message appears 
indicating that the machine is ready.

Is the [POWER SAVE] key (

) 

blinking?

Auto Power Shut-Off mode has activated. To return the 
machine to normal operation, press the [POWER SAVE] 
key (

).

☞

 (page 18)

Is a cover open or a device separated 
from the machine?

A warning message will appear when a cover is open or 
a device is separated from the machine. Read the 
message and take appropriate action.

Did login fail three times in a row?

When "A Warning when Login Fails" is enabled in the 
system settings (administrator) and login fails 3 times in 
a row, a warning will be displayed and operation will 
lock for 5 minutes. After operation unlocks, log in using 
the correct user information. (If you do not know your 
user information, contact your administrator.)