Sharp MX-M1100 操作ガイド

Has the correct paper size been set?

If you are using a special size, be sure to specify the 
paper size.
If the size of paper loaded in a tray was changed, be 
sure to check the paper size setting.

☞

Was the original placed in the correct 
position?

If you are using the document glass, be sure to place 
the original in the far left corner of the document glass.

☞

Is the paper loaded with the print side 
facing in the correct direction?

• Trays 1 to 4:

Load the paper with the front side facing down.

• Bypass tray and tray 5, 6 and 7:

Load the paper with the front side facing up.

Is the USB device compatible with the 
machine?

Ask your dealer if the device is compatible with the 
machine.

Is the connected USB device 
recognized correctly?

Use "USB-Device Check" in the system settings to 
check whether or not the device can be recognized.

☞

 (page 81)

If it is not recognized, connect it once again.

Does a message appear indicating that 
you need to remove paper from the 
stapler compiler?

Remove all remaining paper from the stapler compiler.

Is the [START] key (

) indicator on 

the operation panel turned off?

Configure the settings of punching or stapling on the 
operation panel. For more information, see "

" (page 65)

Does an error message appear?

When the operation does not take place due to the 
problem such as paper misfeeds, you will be informed 
by the operation panel.

Does the following message appear in 
the touch panel?
"Call for service. Code:xx-xx* Please 
check the power of the finisher."
*Letters and numbers appear in xx-xx.

Check peripheral devices and the power plug. Remove 
and then firmly reinsert the power plug, and restart the 
machine.

Have functions been disabled by the 
administrator?

Some functions may have been disabled in the system 
settings (administrator). Check with your administrator.