Sharp MX-M260 ユーザーズマニュアル
117
7
DISPLAY MESSAGES
If one of the following messages appears in the display, take prompt action as instructed by the message.
Message
Cause and solution
Page
ENTER YOUR ACCOUNT
NUMBER.
NUMBER.
Auditing mode is enabled. Enter your account number.
95
A MISFEED HAS OCCURRED.
Remove the misfeed as explained in "MISFEED REMOVAL".
127
2-SIDED COPIES CANNOT BE
MADE ON THIS PAPER TYPE.
MADE ON THIS PAPER TYPE.
This appears when you attempt to make two-sided copies on special
paper that cannot be used for two-sided copying. Cancel two-sided
copying or change the paper.
paper that cannot be used for two-sided copying. Cancel two-sided
copying or change the paper.
16, 28
REMOVE PAPER FROM THE
<*>TRAY.
<*>TRAY.
The indicated output tray is full. Remove the output from the tray.
(<*> indicates the tray that is full.)
(<*> indicates the tray that is full.)
-
CLOSE THE <**> COVER.
The indicated cover is open. Close the cover. (<**> indicates the
cover that is open.)
cover that is open.)
-
PLEASE EXTEND BYPASS-TRAY.
When copying from the bypass tray, be sure to pull out the bypass
tray extension.
tray extension.
19
COVER SHEETS MUST BE THE
SAME SIZE AS THE COPY
PAPER USED.
SAME SIZE AS THE COPY
PAPER USED.
When adding a cover, load paper in the bypass tray that is the
same size as the paper in the tray selected for copying.
same size as the paper in the tray selected for copying.
49
PREPARE A NEW ONE.
The toner cartridge must be prepared.
134
TONER SUPPLY IS LOW.
The toner cartridge must be replaced soon.
134
CHANGE THE TONER CARTRIDGE.
The toner cartridge is out of toner. Replace the toner cartridge.
134
CHECK THE TONER CARTRIDGE.
Make sure that the toner cartridge is installed correctly.
134
THE DOCUMENT FEEDER IS
DISABLED.
DISABLED.
The RSPF has been disabled in the administrator settings. Use
the document glass.
the document glass.
23
SELECTED PAPER TRAY IS
PROHIBITED. PLEASE SELECT
ANOTHER PAPER TRAY.
PROHIBITED. PLEASE SELECT
ANOTHER PAPER TRAY.
This appears when a tray is selected that has been prohibited in
"TRAY SETTINGS" in the system settings.
"TRAY SETTINGS" in the system settings.
92
PLEASE CHECK THE PAPER
SIZE OF TRAY <***>.
SIZE OF TRAY <***>.
The tray's paper size setting is different from the actual paper size.
Load the correct size of paper. The tray is indicated in <***>.
Load the correct size of paper. The tray is indicated in <***>.
16
ADD STAPLES.
The finisher is out of staples. Replace the staple cartridge as
explained in "STAPLE CARTRIDGE REPLACEMENT".
explained in "STAPLE CARTRIDGE REPLACEMENT".
135
PLEASE REMOVE PAPER FROM
THE STAPLER COMPILER.
THE STAPLER COMPILER.
Paper remains in the stapler compiler. Remove the paper.
133
MEMORY IS FULL. PRESS [START]
TO BEGIN COPYING OR [CA] TO
CANCEL.
TO BEGIN COPYING OR [CA] TO
CANCEL.
The memory becomes full while scanning originals. Press the
[START] key ( ) to copy only the originals that have been
scanned, or press the [CLEAR ALL] key ( ) to cancel the job.
[START] key ( ) to copy only the originals that have been
scanned, or press the [CLEAR ALL] key ( ) to cancel the job.
-
07.fm 117 ページ ２００９年７月９日 木曜日 午前１０時４４分