Sharp lc-40c37u 接続ガイド
6
Supplied accessories
NOTE
• Always use the AC cord supplied with the TV.
Make sure the following accessories are provided with the product.
Remote control unit (
g1)
Page 8
Page 8
Page 7
Page 7
Page 7
“AAA” size battery (
g2)
AC cord (
g1)
Cable Clamp (
g1)
Cable tie (
g1)
Operation manual (
g1)
Stand unit (
g1)
Page 6
1.
Confirm the 8 screws supplied with the TV.
NOTE
• To detach the stand, perform the steps in reverse order.
2.
Attach the two parts of the stand unit to each other using
the 4 short screws and the hex key (supplied with the
product) as shown.
product) as shown.
3.
1 Insert the stand into the opening on the bottom of the
1 Insert the stand into the opening on the bottom of the
TV.
2 Insert and tighten the 4 long screws into the 4 holes on
the rear of the TV.
Attaching the stand
• Before attaching (or detaching) stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on.
This will prevent it from being damaged.
• Before performing work spread cushioning over the base area to lay the TV on.
This will prevent it from being damaged.
Short screws (
m4)
(used in step 2)
Long screws (
m4)
(used in step 3)
1
2
QUICK REFERENCE
Hex key
Hex key
Short screw
Soft cushion
Long screw
CAUTION
• Attach the stand in the correct direction.
• The “REAR” label should be visible from the back of the TV. Refer to
• The “REAR” label should be visible from the back of the TV. Refer to
the figure.
• Incorrect installation of the stand may result in the TV falling over.
• Be sure to follow the instructions.
• Be sure to follow the instructions.
REAR
This side faces the rear.