Amana AEP222VA インストール手順

6. Use

³⁄₈" nut driver to connect the neutral (white) wire to the

center terminal block post with one of the 10–32 hex nuts.

7. Connect line 1 (black) and line 2 (red) wires to the outer

terminal block posts with 10-32 hex nuts.

8. Securely tighten hex nuts.

9. Replace terminal block access cover.

3-wire connection: Direct Wire

Use this method only if local codes permit connecting ground
conductor to neutral supply wire.

1. Pull the conduit through the strain relief on cord/conduit plate

on bottom of range. Allow enough slack to easily attach the
wiring to the terminal block.

2. Attach terminal lugs to line 1 (black), bare (green) ground, and

line 2 (red) wires. Loosen (do not remove) the set screw on the
front of the terminal lug and insert exposed wire end through
bottom of terminal lugs. Securely tighten set screw to torque

as shown in the following Bare Wire Torque Specifications
chart.

Bare Wire Torque Specifications

Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m)

3. Use

³⁄₈" nut driver to connect the bare (green) ground wire to

the center terminal block post with one of the 10–32 hex nuts.

4. Connect line 1 (black) and line 2 (red) wires to the outer

terminal block posts with 10-32 hex nuts.

5. Securely tighten hex nuts.

6. Replace terminal block access cover.

A. 10–32 hex nut
B. Line 1 (black)

C. Bare (green) ground wire
D. Ground-link screw

E. Neutral (white) wire
F. Line 2 (red)

G. Terminal lug

A. Terminal block
B. Ground-link screw

C. Cord/conduit plate

D. Line 2 (red) wire

E. Bare (green) ground wire
F. Line 1 (black) wire

A. Terminal lug
B. Set screw

C. Line 1 (black) wire
D. Bare (green) ground wire

E. Line 2 (red) wire

Wire Awg

Torque

8 gauge copper

25 lbs-in. (2.8 N-m)

6 gauge aluminum

35 lbs-in. (4.0 N-m)

A. 10–32 hex nut
B. Line 1 (black)

C. Ground-link screw

D. Bare (green) ground wire

E. Line 2 (red)

F. Terminal lug