Amana 658030-ak 8" dado set ユーザーガイド

MACHINE SET-UP

(cont.)

It is advisable to line up the ATB teeth on both
outside blades in order to take an accurate
measurement.

f.) If using a table saw, replace the table insert with

the proper type. Warning: Never attempt any
cutting without the table insert in place. The
work-piece must properly supported near the
cutting area.

g.) Check all guards and safety devices before

restoring power.

h.) Perform a test cut to check the set-up.
i.) Warning: Both outside dado blades must be

used. Never attempt to use the chippers without
both outside blades in place.

DADO SIZE CHART

NOTE:

The information provided below is intended

as a guide only and does not account for any
re-sharpening or normal manufacturing and run-out
tolerances. As always, measure twice - cut once.

*NOTE:

With assemblies requiring shims, it is

advisable to spread them out between different
components as opposed to stacking them all together.

Outside Outside

Inside

*Shims

Groove

Blade Blade Chippers

Gold Yellow Clear White

Size

R/H

L/H

1/16" 1/8" 1/4"

.002" .004"

.010" .020"

.257”

.312” (5/16”)

.320”

.343” (11/32”)

.375” (3/8”)

.382”

.437” (7/16”)

.445”

.468” (15/32”)

.472” (12mm)

.500” (1/2”)

.507”

.562” (9/16”)

.570”

.593” (19/32”)

.625” (5/8”)

.629” (16mm)

.687” (11/16”)

.695” 1

.708” (18mm)

.718” (23/32”)

.750” (3/4”)

.812” (13/16”)

.820”