Jet jbg-10a ユーザーズマニュアル

 

9

Refer to Figure 2: 

Parts needed: 

2  Spark Guard and Eye Shield Brackets 

assembled from previous page 

4  1/4” x 3/8” Hex Cap Screws  (E) 
4  1/4" Flat Washers  (F) 
 

1.  Install the left spark guard and mounting 

bracket (A) to the left wheel housing (M) with 
two 1/4” x 3/8” hex cap screws (E) and two 1/4" 
flat washers (F). 

The  spark guards (A

1

) should be adjusted to 

within  1/16"  of the grinding wheel surface or 
other accessory being used. 

2.  Install the right spark guard and mounting 

bracket in the same manner. 

Note: As the wheel wears down, the spark guards 
must be re-adjusted to maintain the 1/16" distance. 

Refer to Figure 2: 

Parts needed: 

2  Tool Rest Left (J) and Right (not shown) 
4  5/16" x 3/4" Hex Cap Screws (C) 
4  5/16" Flat Washers (D) 
 

Note: There is a left and a right tool rest. Refer to 
Figure 1 to ensure that you install them correctly. 

1. Install the left tool rest (J) by threading two 

5/16" x 3/4" hex cap screws (C) through two 
5/16" flat washers (D) and the tool rest (J) into 
the wheel housing (M). 

The tool rests should be adjusted to within 
1/16" of the grinding wheel or other accessories 
being used. As the wheel wears down, the tool 
rest must be re-adjusted to maintain a 1/16" 
clearance. 

2. Install 

the 

right tool rest in the same manner. 

Refer to Figure 2. 

Parts needed: 

4  3/16” x 3/8” Pan Head Screws  (H) 
2  Eye Shields  (L) 
2  Eye Shield Bracket Plates (G) 

 
The  eye shields (L) are identical and will fit on 
either side of the grinder. 

 
 

 

 
To install eye shields (refer to Figure 2): 

Insert two 3/16” x 3/8” pan head screws (H) through 
the mounting plate (A

2

), eye shield (C), and bracket 

plate (G) containing threaded mounting holes. 

Tighten the screws (H). 

To prevent the grinder from moving during 
operation, it should be securely mounted to a work 
surface or grinder stand. 

1.  Align the mounting holes on the grinder with 

predrilled holes in a bench or grinder stand. 

2.  Insert bolts through the holes and tighten, using 

washers and nuts (not included).