Jet jj-6csdx ユーザーズマニュアル
25
Beveling
To cut a bevel, lock the fence at the required angle
and run the work piece across the knives while
keeping it firmly against the fence and tables.
Several passes may be necessary to achieve the
desired result.
and run the work piece across the knives while
keeping it firmly against the fence and tables.
Several passes may be necessary to achieve the
desired result.
Although the fence may be
tilted in or out for a bevel cut, it is
recommended for safety reasons that the fence
be tilted in toward the operator, making a
cradled cut.
recommended for safety reasons that the fence
be tilted in toward the operator, making a
cradled cut.
Direction of Grain
Avoid feeding work into the jointer against the
grain. This may result in chipped and splintered
edges. See Figure 39. Feed with the grain to
obtain a smooth surface, as shown in Figure 40.
grain. This may result in chipped and splintered
edges. See Figure 39. Feed with the grain to
obtain a smooth surface, as shown in Figure 40.
Maintenance
Blade Care
Blades are extremely sharp!
Use caution when cleaning or
Use caution when cleaning or
changing. Failure to comply may cause
serious injury!
serious injury!
When gum and pitch collect on the blades,
carefully remove with a strong solvent. Failure to
remove gum and pitch build up may result in
excessive friction, blade wear and overheating.
carefully remove with a strong solvent. Failure to
remove gum and pitch build up may result in
excessive friction, blade wear and overheating.
When blades become dull, touch up blades. See
Sharpening the Knives.
Sharpening the Knives.
Sharpening the Knives
Blades are extremely sharp!
Use caution when handling.
Use caution when handling.
Failure to comply may cause serious injury!
1. Disconnect the machine from the power
source.
2. Remove the blade guard and belt cover.
3. To protect the infeed table from scratches,
partially cover the sharpening stone with paper
(Figure 41).
(Figure 41).
4. Lay the stone on the infeed table.
5. Lower the infeed table and turn the cutterhead
by turning the cutterhead pulley. The infeed
table height is set properly when the stone's
surface is flush with the knife bevel.
table height is set properly when the stone's
surface is flush with the knife bevel.
6. Keep the cutterhead from rotating by grasping
Figure 39
Figure 40
Figure 41
the cutterhead pulley while sliding the stone
back and forth across the table.
back and forth across the table.
7. Take the same amount of passes for all three
blades.
When the blades have been sharpened and still are
not cutting efficiently, trying to touch up the blades
further will only cause the formation of a second
beveled edge. When this starts to happen, it is time
to replace blades with another set. It is
recommended to keep a second set of blades on
hand so that they may be installed while the first set
is being professionally sharpened.
not cutting efficiently, trying to touch up the blades
further will only cause the formation of a second
beveled edge. When this starts to happen, it is time
to replace blades with another set. It is
recommended to keep a second set of blades on
hand so that they may be installed while the first set
is being professionally sharpened.