Jet jj-8cs ユーザーガイド

The JJ-8CS and JJ-8HH jointers are rated at
230V, single phase only. Confirm that the
power at the source is compatible with the
jointer before inserting plug into the outlet. The
jointer is designed to be used with a plug and
outlet similar to that shown in Fig. 12.

Important: Make certain the receptacle in
question is properly grounded. If you are
not sure, have a registered electrician check
the receptacle.

Extension Cords

Make sure the rating of the extension cord is
suitable for the amperage listed on the
machine’s motor plate. An undersize cord will
cause a drop in line voltage resulting in loss of
power and overheating.

Use the chart in Figure 13 as a general guide in
choosing the correct size cord. If in doubt, use
the next heavier gauge. The smaller the gauge
number, the heavier the cord.

Adjustments

90° Fence Adjustment

Note: whenever making an adjustment to the
fence, lift the fence up slightly after releasing the
lock handle to avoid scratching the table.

1. Set infeed table to the same height as the

outfeed table.

2. Move the fence by releasing lock handle (A,

Fig. 14) and pushing the fence assembly
until it overlaps the tables.

3. Adjust the fence to a 90

angle by releasing

lock handle (B, Fig. 14), pulling up on
handle (C, Fig. 14), and re-tightening lock
handle (B, Fig. 14).

4. Place a combination square on the infeed

table. (Fig. 15)

5. If fence is not square to table, release lock

handle (B, Fig. 14), loosen nut (D, Fig. 14),
and turn bolt (E, Fig. 14) until fence is
square to table.

6. Tighten nut (D, Fig. 14) to retain the setting.

Tighten lock handle (B, Fig. 14).

Figure 12

Recommended Extension Cord Gauges (AWG)

Extension Cord Length in Feet *

Amps

25 50 75 100 150 200

16 16 16 14 12 12

5 to 8

8 to 12

12 to 15

15 to 20

21 to 30

*based on limiting the line voltage drop to 5V at 150% of the
rated amperes.
NR: Not Recommended.

Figure 13

Figure 14

Figure 15