Jet 577001 j-4126ac - vari-speed square wheel grinder ユーザーガイド
7
Introduction
This manual includes operating and maintenance instructions for the JET Model J-4103 and J-4126AC Square
Wheel Belt Grinder. The manual also includes parts listings and illustrations of replaceable parts.
Wheel Belt Grinder. The manual also includes parts listings and illustrations of replaceable parts.
Refer to Figures 1 and 2 for key features of the Square Wheel Belt Grinder.
Figure 2: Square Wheel Grinder Features
(variable speed)
Figure 1: Square Wheel Grinder Features
(single speed)
Setup and Operation
The Square Wheel Belt Grinder can be mounted on a work bench or an optional pedestal. The grinder should
be secured to the work bench or pedestal using the four holes in the base of the grinder. (Refer to Assembly
of Pedestal for machines that are to be pedestal-mounted.)
be secured to the work bench or pedestal using the four holes in the base of the grinder. (Refer to Assembly
of Pedestal for machines that are to be pedestal-mounted.)
Installation of Work Rest
The work rest mounts on the left side of the head casting. Attach the work rest using the socket head cap
screw provided with the machine.
screw provided with the machine.
The slot in the work rest has a lip against which the cap screw is tightened. Place the hole at the end of the slot
over the cap screw. Then slide the rest inward until the work rest is in position in front of the contact wheel.
Tighten the cap screw.
over the cap screw. Then slide the rest inward until the work rest is in position in front of the contact wheel.
Tighten the cap screw.
Belt Tension Lever
Motor
Switch
Upper
Guard
Guard
Belt Tracking
Adjustment
Adjustment
Contact
Wheel
Wheel
Work
Rest
Rest
Pedestal
Belt Tracking
Adjustment
Adjustment
Pedestal
Contact
Wheel
Wheel
Upper
Guard
Guard
Motor
Inverter
ON/OFF
Switch
Switch
Work
Rest
Rest