Jet swivel band saw w ユーザーガイド
8
Read and understand the entire contents of this manual before attempting set-up
or operation! Failure to comply may cause serious injury.
Assembly of Stand
Tools required for assembly:
Two 1/2-inch wrench (Note: A ratchet wrench
may speed assembly time.)
may speed assembly time.)
1. Assemble left (A) and right (B) side plates
with six 5/16"x3/4" hex cap screws (C
1
),
twelve 5/16” flat washers (D
1
) and six 5/16"
hex nuts (E
1
). Tighten the hex nuts.
2. Turn the assembly (from Step 1) on its back
(door opening up) and mount the bottom
plate (F) with two 5/16"x3/4" hex cap screws
(C
plate (F) with two 5/16"x3/4" hex cap screws
(C
2
), four 5/16” flat washers (D
2
) and two
5/16" hex nuts (E
2
). Tighten the hex nuts.
3. Install the two rubber feet (G) on the bottom
of the left plate (A).
4. Turn the assembly upside down and install
the wheel base (H) with four 5/16"x3/4" hex
cap screws (C
cap screws (C
3
), eight 5/16” flat washers
(D
3
) and four 5/16" hex nuts (E
3
).
5. Insert
the
axle (J) through the holes of the
wheel base (H).
6. Install a wheel (K) and two 5/8”x30
flat
washers (L) on each end of the axle. Insert
cotter pins (M) through holes on each end of
the axle and bend the ends of the cotter pins
to secure the wheel on the axle.
cotter pins (M) through holes on each end of
the axle and bend the ends of the cotter pins
to secure the wheel on the axle.
7. Install
the
handle (N) to the left side plate (A)
with four 5/16”x1-1/2” hex cap screws (O),
four 5/16” flat washers (D
four 5/16” flat washers (D
4
) and four 5/16"
hex nuts (E
4
). Tighten the hex nuts.
8. Install
the
door (P). The upper hinge pin is
spring loaded and must be retracted to
mount the door to the cabinet.
mount the door to the cabinet.
9. Install the door lock knob with a 5/16" flat
washer (D
5
) and 5/16" nylon nut (R).
Installation of the chip pan (R) is described in
Mounting Band Saw to Stand on the following
page.
Mounting Band Saw to Stand on the following
page.
Figure 1