Maytag mvwc5es ユーザーガイド

6.   Select Temperature and Soil Level Option.

7.   Select Extra Rinse Option, if desired.

9.  Start the washer by pulling out the Cycle control knob.

 

NOTE: For best water savings, avoid stopping the washer.  

However, if the washer does need to be stopped:

To stop at any time, push in the Cycle Control knob.

 

■

To restart, close the lid and pull out the Cycle Control knob.

 

■

Use a soft, damp cloth or sponge to wipe up any spills such as 

detergent or bleach from the outside of your washer.

Clean your washer interior by mixing 1 cup (250 mL) of chlorine 

bleach and enough detergent to equal twice the manufacturer’s 

recommended amount for a normal wash load. Pour this mixture 

into your washer and run it through a complete cycle using hot 

water. Repeat this process if necessary.

Remove any hard water deposits using only cleaners labeled as 

washer safe.

1.   Remove dispenser by grasping top with both hands and 

squeezing, while pushing upward with thumbs.

2.  Rinse dispenser under warm water, then replace it.
NOTE: To avoid damage to the washer or clothing, do not wash 

clothes with the liquid fabric softener dispenser removed.

This washer does not include water inlet hoses. The use of 

factory specified parts is recommended. See “Accessories” for 

a list of factory specified hoses available for separate purchase. 

These hoses are manufactured and tested to meet factory 

specifications. 

Replace inlet hoses after 5 years of use to reduce the risk of hose 

failure. Periodically inspect and replace inlet hoses if bulges, 

kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, mark the date of replacement 

on the label with a permanent marker.

Because some water may stay in the hoses, freezing can damage 

your washer. If storing or moving your washer during freezing 

weather, winterize it.

1.  Shut off both water faucets. Disconnect and drain water inlet 

hoses. Pour 1 qt (1 L) of R.V.-type antifreeze into the basket.

2.  Run washer on a drain and spin setting for about 30 seconds  

to mix the antifreeze and remaining water.

3.  Unplug washer or disconnect power.

1.   Flush water pipes and hoses. Reconnect water inlet hoses. 

Turn on both water faucets.

2.  Plug in washer or reconnect power.
3.   Run the washer through a complete bulky items cycle with  

1 cup (250 mL) of detergent to clean out antifreeze.

Operate your washer only when you are at home. If you will be on 

vacation or not using your washer for an extended period of time, 

you should:

1.  Unplug washer or disconnect power.
2.   Turn off the water supply to the washer. This helps avoid 

flooding (due to a water pressure surge) while you are away.

8.   To select cycle, push the Cycle Control knob in and turn 

clockwise to the cycle you want.