Maytag fav6800a ユーザーガイド

day’s washing. This will shut off the water supply to

the washer and prevent the unlikely possibility of damage

from escaping water.
Use a soft cloth to wipe up all detergent, bleach or other

spills as they occur.

Clean the following as recommended:

Control Panel – clean with a soft, damp cloth.

Do not use abrasive powders or cleaning pads.

Do not spray cleaners directly on the panel.

Cabinet – clean with soap and water.

The detergent, fabric softener and bleach dispensers

may need to be cleaned periodically due to laundry

additive buildup.
Detergent Dispenser:
1. Remove the dispenser by releasing the top end

from the lid with a quarter or something similar.

2. Take the dispenser to a sink.
3. Wash thoroughly with plain water and soft brush

if necessary.

4. Rinse and dry the dispenser.
5. Replace dispenser in washer lid by fitting the

bottom in first, then snapping the top all the way in.

Important: Make sure all three tabs on the

dispenser bottom are securely fastened to the lid.

6. Do not clean the dispenser in the dishwasher.

Chlorine Bleach Dispenser:
The dispenser cover is not removable.
Wipe thoroughly with a clean, damp cloth or paper

towel.

Fabric Softener Dispenser:
The rear portion of the fabric softener dispenser cover is

removable for cleaning.
1. Grasp the rear portion of the cover and pull

straight up.

2. Wash with hot, soapy water and a soft cloth.

Rinse and dry thoroughly.

3. Wipe dispenser compartment with a dry paper

towel to remove buildup. Follow with a clean,

damp cloth or paper towel.

4. Replace dispenser cover.
5. Do not clean the dispenser cover in the

dishwasher.

Clean the interior of the washer periodically to

remove any dirt, soil, odor, mold, mildew or bacteria

residue that may remain in the washer as a result of

washing clothes. We recommend taking the

following steps every 60 to 120 days to clean and

freshen your washer interior. The frequency with

which the washer should be cleaned and freshened

depends on factors such as usage, the amount of

dirt, soil or bacteria being run through your washer,

or the use of cold water. Failure to follow these

instructions may result in unsatisfactory conditions,

including unpleasant odor and/or permanent stains

on the washer or washload.

1. Select Heavy Duty cycle, Hot/Cold water

temperature, Heavy soil level and the Max

Extract spin option.

2. Press Start/Pause and wait until the washer

has stopped filling with water

water:
1. Press Start/Pause and lift the lid.
2. Add 1/2 cup liquid chlorine bleach to the water in

the tub.

3. Close the lid and press Start/Pause to restart

the washer.

4. Allow the washer to complete the cycle.

NOTE: The dispenser MUST ALWAYS be in place

before starting the washer.