Electrolux ei23ss55 ユーザーガイド

The 

TM

 ice and water 

filter system is tested and certified 
by NSF International, the nationally
respected, not-for-profit certification 
organization for public health safety. 

The 

TM 

ice and water filter system 

is tested and certified to ANSI/NSF Standards 42
and 53 for the reduction of claims specified on the 
performance data sheet. 

Do not use with water that is microbiologically
unsafe or of unknown quality without adequate 
disinfection before or after the system. Systems 
certified for cyst reduction may be used on 
disinfected waters that may contain filterable cysts. 

 •  Rated Capacity - 400 gallons for

TM

 ice and water filter

 •  Rated service flow - .5 gallons per minute
 •  Maximum Rated Pressure - 100 pounds per

square inch

 •  Operating Temp.: Min. 33° F, Max. 100° F
 •  Recommended Minimum Operating

Pressure: 30 pounds per square inch

It is not necessary to turn the water supply off 
to change the filter. Be ready to wipe up any 
small amounts of water released during the filter 
replacement.

 

1  Turn Off the ice maker power switch.   

 

2   Push the filter release button below the 

cartridge to disconnect it.

 

3  Slide the old water filter cartridge straight out 

of the housing and discard it.

 

4  Unpackage the new filter cartridge and slide 

it gently into the filter housing until it stops 
against the snap-in connector at the back of 
the housing.

 

5  Push firmly until the cartridge snaps 

into place (you should hear a click as the 
cartridge engages the snap-in connector). 
When fully engaged, the front of the filter 
cartridge should be flush with the filter 
release button.

 

6  Press a drinking glass against the water 

dispenser while checking for any leaks at the 
filter housing. Any spurts and sputters that
occur as the system purges air out of the 
dispenser system are normal.

 

7  After filling one glass of water, continue

flushing the system for about 

three minutes.

 

8  Turn On the ice maker power switch (see 

page 18 for more about turning on the ice 
maker).

 

9  Press and hold the Filter Status button on 

the Ice & water Dispenser control panel for
three seconds. When the display changes 
from “

Replace” to “Good,” the status has 

been reset.