IQinVision iqm30ne-b5 インストール手順

1.  Press and hold the “Reset” button for  

10 seconds as illustrated in Figure 11.1.

1.  Attach the tether from the dome trim ring to the  

tether mounting point in the enclosure as shown in 

Figure 12.1.

2.  Rotate the black shroud inside the dome trim ring 

cover so it aligns with the camera position.

3.  Place the supplied desiccant pack inside the dome as  

shown in Figure 12.2 to prevent fogging due to 

moisture that is present when installing the camera.  

Use the supplied cable tie to keep the desiccant from 

falling down into the dome bubble.

4.  Attach the dome trim ring cover with shroud to the  

enclosure by tightening the three tamper-proof screws  

with the supplied Torx T-20 security wrench.

NOTE: The default user name for all IQeye devices is “root” and the default 
password is “system”.

IQeye cameras are configured for DHCP and will have an IP address assigned if 
a DHCP server is on the network. If a DHCP server is not available, the camera IP 
address will need to be configured using either IQfinder or IQmanager depending on 
the number of cameras being installed.