Aria 714-std ユーザーガイド

ページ / 6
 
- 5 -
   
01english_ownersmanual_0831.doc
 
Control 
Control of electric guitar & bass 
Different models feature some or all of the following controls. 
VOLUME: Adjusts volume level. Turning to the right, volume increases. Turn it to the left, volume is decreased 
TONE: Turn to the left high frequencies are cut. 
PICKUP SELECTOR: Selects combination of pickups. 
COIL SPLIT SWITCH: Cancels one coil of a Humbucking pickup, giving a sigle coil sound. 
BALANCE CONTROL: Adjusts the balance volume between two pickups. 
 
 
 
 
Control of electric acoustic guitar 
The volume and tone of a piezo pickup is controlled via a built in  
Equalizer.   
 
The  jack  socket  acts  as  a  switch,  so  unplug  when  the  guitar  is  not  being  used  and  you  will  prevent  the 
unnecessary draining of your battery.  
You will notice a drop in volume and an increase in background noise as the battery dies. Change batteries in 
advance of an important performance!  
 
VOLUME: Adjusts volume level. 
TREBLE: Adjusts tone of high frequency range. 
MIDDLE: Adjusts tone of middle frequency range. 
BASS: Adjusts tome of low frequency range. 
PRESENCE/BRILLANCE: Adjusts tone of extremely high frequency range. 
FREQUENCY/CONTOUR: Use to select frequency range to be controlled by the MIDDLE control. 
PHASE: Phase reverse switch, can be used to eliminate feedback (that annoying howling sound). 
MUTE:  Mutes output volume. 
NOTCH/SCOOP: Allows you to reduce the frequencies causing feedback. 
BATTERY: When battery capacity becomes low, LED Light becomes weak.  For the "Fishman" equalizer, LED 
light glows when the battery capacity is low. 
 
    
Adjustment of Guitar 
If you feel confidant tackling minor adjustments to your guitar then you will find the information below, helpful. If 
in doubt seek professional advice. 
 
Neck adjustment (Electric / Electric bass / Acoustic guitar) 
An incorrectly adjusted or in the worst case, a warped neck, will result in fret buzz or a note ‘choking’. If the 
action (distance between the string and the fret) is too low, you will also notice string buzz. 
 
Any checking of the neck should be done whilst the guitar is tuned to ‘concert pitch’ 
By sighting down the neck from the headstock end you will be able to easily see if the neck is bowed or arched 
excessively. 
Any excessive bow or arch can be rectified by tightening or loosening the truss-rod, which is mounted inside the 
neck.
 
 
(1) excessive bow 
(2) excessive arch 
 
 
Slacken the strings before adjusting the truss rod. 
The truss rod adjuster location varies from model to model, but will be either at the body end of the neck or at 
the headstock end, sometimes below a truss rod cover. The correct wrench will have been shipped with the 
guitar. As you would expect, turn clockwise to tighten and anti-clockwise to loosen. 
 
 
[Tighten][Loosen]