DeWALT dxcmh1608wb 5.5 hp 8 gallon oil-lube wheelbarrow air compressor ユーザーガイド

English

PrEPArAtIon For uSE
Pre-Start Checklist (Fig. 1)

1. Ensure engine ON/OFF switch (C) is in the OFF position.
2. Ensure air tank is drained, see

Draining Air tank under

Maintenance.

3. Ensure the drain valve (J) is closed.
4. Ensure safety valve (I) is functioning properly, see

Checking

safety Valve under Maintenance.

5. Check pump oil level, see

Compressor Pump oil under

Maintenance.

NOTICE: Do not operate without oil or with inadequate oil. D

WALT

is not responsible for compressor failure caused by inadequate oil.
6. Check engine's oil and fuel level, see engine's instruction manual

for correct procedures.

7. Visually inspect drive belt. Replace belt if frayed, cracked, or

worn.

note: Outer belt cover must be removed to inspect drive

belt.

8. Ensure all guards, covers, and labels are in place, legible (for

labels) and securely mounted. Do not use compressor until all

items have been verified.

Initial Set-up (Fig. 1)

WARNING: Do not operate this unit until you read and understand

this instruction manual and the engine instruction manual for safety,

operation and maintenance instructions.
BreAk-In ProCeDure
NOTICE: Risk of property damage. Serious damage may result if the

following break-in instructions are not closely followed.
this procedure is required:
• Before the air compressor is used for the first time.

• When the unloader valve has been replaced.
• When the compressor pump has been replaced.
the procedure:
1. Follow

Pre-start Checklist under Preparation for Use.

2. Rotate the unloader's manual lock to the

open position to

prevent air tank pressure buildup.

3. Open the pressure regulator. Pull regulator knob (F) out and

rotate clockwise until it stops.

WARNING: Do not operate this unit until you read and understand

the engine instruction's manual for safety, operation and maintenance

instructions.
4. Prepare engine for first time use, see engine's instruction manual

for correct procedure.

5. Turn the engine ON/OFF switch (C) to the ON position.
6. Place the fuel valve lever (O) in the ON postion.
7. If the engine is cold, move the

OPEN

CLOSED

N
O OFF

choke (N) to the CLOSED position

as shown. If the engine is hot,

move the choke to the OPEN

position.

WARNING: Risk of unsafe opera-

tion. Pull starter grip slowly until resis-

tance is felt. Then pull starter grip (P)

rapidly to avoid kickback and prevent hand or arm injury.
NOTICE: Do not allow the starter grip to snap back. Return it gently

by hand.
note: If the engine does not start, check the oil level and add oil

as needed.
note: To ensure maximum oil lubrication, place the unit on a level

surface.