Milan mil-sm24004tg インストール手順
Introduction
1-4
1
Optional Redundant Power Unit
The switch supports an optional Redundant Power Unit (RPU) that can supply
power to the switch in the event of failure of the internal power supply.
power to the switch in the event of failure of the internal power supply.
Power Supply Receptacles
There are two power receptacles on the rear panel of the switch. The standard
power receptacle is for the AC power cord. The receptacle labeled “RPU” is for the
optional Redundant Power Unit (RPU).
power receptacle is for the AC power cord. The receptacle labeled “RPU” is for the
optional Redundant Power Unit (RPU).
Figure 1-4 Power Supply Receptacles
Features and Benefits
Connectivity
• 24 10/100/1000 Mbps ports for easy Gigabit Ethernet integration and for protection
of your investment in legacy LAN equipment.
• Auto-negotiation enables each RJ-45 port to automatically select the optimum
communication mode (half or full duplex) if this feature is supported by the
attached device; otherwise the port can be configured manually.
attached device; otherwise the port can be configured manually.
• RJ-45 ports support auto MDI/MDI-X pinout selection.
Table 1-2 System Status LEDs
LED
Condition
Status
Power
On Green
Internal power is operating normally.
On Red
Internal Power supply fault.
Off
Power off or failure.
Diag
Flashing Green
System self-diagnostic test in progress.
On Green
System self-diagnostic test successfully completed.
On Red
System self-diagnostic test has detected a fault.
RPU
On Green
Redundant power unit is receiving power.
On Red
Fault in redundant power unit.
Off
There is no redundant power unit currently attached.
100-240V~, 50-60Hz 2A
RPU
DC IN
12V 8.5A
12V 8.5A
Redundant Power Socket
Power Socket