Milan mil-sm24004tg インストール手順

ページ / 58
A-2
Troubleshooting
A
Installation
Verify that all system components have been properly installed. If one or more 
components appear to be malfunctioning (such as the power cord or network 
cabling), test them in an alternate environment where you are sure that all the other 
components are functioning properly.
In-Band Access
You can access the management agent in the switch from anywhere within the 
attached network using Telnet, a Web browser, or other network management 
software tools. However, you must first configure the switch with a valid IP address, 
subnet mask, and default gateway. If you have trouble establishing a link to the 
management agent, check to see if you have a valid network connection. Then 
verify that you entered the correct IP address. Also, be sure the port through which 
you are connecting to the switch has not been disabled. If it has not been disabled, 
then check the network cabling that runs between your remote location and the 
switch.
Caution:  The management agent can accept up to four simultaneous Telnet sessions. If 
the maximum number of sessions already exists, an additional Telnet 
connection will not be able to log into the system.