Garmin 101 クイック設定ガイド

ページ / 2
➋ 
Starting Up the Foretrex 101
After installing batteries in the Foretrex 101, it is ready for use.  
To turn on the Foretrex 101: 
1.  Press and hold the 
POWER 
button until the Satellite Page is 
displayed.  
2.  Allow the Foretrex time to track satellites the first time you use 
it.  Leave the Foretrex outside with a clear view of the sky for 
15–30 minutes.  After the first use, it should take less than one 
(1) minute to acquire satellites.  
3.  When the Foretrex acquires enough satellite signals to 
determine your location, “3D GPS FIX” or “2D GPS FIX” is 
displayed, and the satellite dish icon in the upper left corner of 
the screen stops flashing.  Also, the Signal bar fills up to show 
the strength of the satellite signal.  
Foretrex 101 Icons
Three icons in the upper left-hand corner provide at-a-
glance-status of the Foretrex: battery, stopwatch (timer), and 
satellite dish icon.  
Battery icon: The battery icon indicates how much 
power the batteries have.  A full battery icon indicates new  
batteries are installed in the Foretrex 101.  
Timer icon: When the timer feature of the Foretrex is 
being used, the stopwatch (timer) icon displays just below 
the battery icon.  
Satellite Dish icon: When the Foretrex has acquired 
enough satellites to establish your GPS location fix, this icon 
displays solid (not flashing) just below the timer icon.  The Satellite 
Dish icon flashes while it is acquiring satellites and determining 
your location.  
➌ 
Changing the Pages
Press the PAGE button to cycle through the main pages: The 
Satellite Page, Map Page, Navigation Page, Trip Computer, Timer 
Page (if enabled), and the Menu Page.
Satellite Page - Provides notice of satellites being tracked.
Map Page - Displays your movements.
Navigation Page - Provides guidance to your destination.
Trip Computer Page - Provides information about your trip, 
such as speed, maximum speed, and current location.  The data 
fields are completely customizable to fit your needs.
Timer Page (if enabled) - Provides an advanced timer great for 
a variety of applications such as sailboat racing.
Menu Page - Provides access to features and settings.
Refer to the Foretrex Owner’s Manual for complete information 
on all of the Foretrex’s pages.  
➍ 
Setting the Time Zone
When the Foretrex is ready for use, you may need to check the 
Time Zone selection.  The time is set automatically as soon as the 
unit establishes a fix on the GPS satellites.  The current date and 
time is displayed on the top of the screen.  When the Foretrex has 
established a GPS fix, U.S.  Central Time is selected as the default 
Time Zone.  
To change the Time Zone:
1.  Press the 
PAGE 
button to display the Menu Page.
2.  Press the 
DOWN 
button to highlight ‘
SETUP
’.  Press 
ENTER
.
3.  Press Enter when ‘
SET TIME
’ is highlighted.  
4.  To change the Time Zone, use the 
UP/DOWN 
buttons to select 
TIME ZONE’
 and press 
ENTER
.
5.  Use the 
UP/DOWN 
buttons to select the correct time zone and 
press 
ENTER
.
 Installing Batteries
The Foretrex 101 operates on two AAA alkaline batteries (not 
included), which are placed in the back of the unit.  Rechargeable 
alkaline, NiMH, NiCad, or lithium batteries may be used.  See the 
section titled “Set System Page” in the Owner’s Manual for instruc-
tions on selecting battery type.
Stored data is not lost when you change the batteries.  However, 
if batteries are completely discharged and are not changed within a 
couple of days, it may take longer for the unit to get a GPS signal fix.
To install the batteries:
1.  Remove the battery cover by inserting a coin in the bottom 
slot.  Twist the coin to lift the cover up and pull away.
2.  Compare the battery polarity with the diagram in the battery 
compartment and install the batteries accordingly.
+
-
- +
Installing two AAA batteries
3.  To re-install the battery cover, slide the top portion into the 
appropriate slot, then snap the bottom section securely to the 
base of the unit.
Foretrex 101 Battery Life
Your Foretrex 101 should get about 14–15 hours of use before 
the batteries need to be replaced.
➎ 
Adjusting the Display
To adjust the light timeout and contrast:
1.  Use the 
PAGE 
button to access the Satellite Page.
2.  Press and release the 
ENTER 
button to display the Options 
Menu.
3.  Press 
ENTER 
to display the Display Setup Page.
4.  Press 
ENTER 
when the line below “
LIGHT TIMEOUT
” is 
highlighted.  Use the 
UP/DOWN
 buttons to select the desired 
length of time for the backlight timeout.  Press 
ENTER 
to select 
the highlighted length of time.
5.  Use the 
UP/DOWN
 buttons to select the slider bar below the 
CONTRAST
’ field.  Press the Enter button to select the slider 
bar to adjust the contrast.  Use the 
UP/DOWN
 buttons to 
adjust the contrast.  Press 
ENTER 
when done.  
To turn the backlight On and Off:
1.  Press the 
POWER 
button to turn the backlight On.
2.  Press 
POWER 
again to turn the backlight Off.  
3.  If no other button is pressed, the backlight turns off 
automatically after 30 seconds or whatever time you have set 
through the Display Setup Page, which can be accessed from 
the Main Menu or the Satellite Page.  
➏ 
Adjusting the Strap
The Foretrex has been designed to comfortably fit your wrist.  A 
strap extension provides additional length and easily attaches to the 
existing strap.  
To add the strap extension:
1.  Slide the end of the existing strap through the connector on 
the extension.
2.  Place on your wrist or arm.  
3.  Slide the end of the extension through the existing connector.  
4.  Adjust to fit comfortably and secure the strap.  
Refer to the Owner’s Manual for complete instructions.
Using the Foretrex 101 Buttons
ENTER/ 
MARK
UP
DOWN
PAGE
GOTO
POWER
The POWER button:
•  Press and hold to turn unit on and off 
•  Press and release to turn display backlight on and off
The GOTO button:
•  Press to initiate a GoTo (navigate to a specific destination/
waypoint)
The PAGE button:
•  Press to switch between the main Pages
•  Press to back out or escape out of the present page or screen
The ENTER/MARK button:
•  Press to confirm data entry or menu selection
•  Press and hold to mark a waypoint
The UP/DOWN buttons:
•  Highlight options on pages and menus
•  Adjust display contrast
•  Zoom out (UP) and in (DOWN) on Map Page
•  Cycle through data fields on Navigation Page
Foretrex 101 Setup
Foretrex 101 Setup
Foretrex 101 Setup
Foretrex 101 Buttons
Foretrex 101 Setup