Garmin 196 インストール手順

To attach the yoke mount to the yoke shaft or control arm:

1. Open the clamp by turning the clamp adjustment knob counter-clockwise until it

can be easily placed over the yoke shaft or control arm.

2. When in place, tighten the clamp adjustment knob.
3. Use the pivot knob to position the yoke mount.

To install the GPSMAP 196/296/396 in the yoke mount:

1. Make required auxiliary power,

mini USB, and remote GPS

antenna cable connections on

the back of the unit. Clip the

GPSMAP 196/296/396 into the

cradle of the yoke mount.

2. Slide the locking lever

on the side of the cradle

forward to secure the

GPSMAP 196/296/396 in

place.

3. Adjust the cradle for best

viewing and operation of the

GPSMAP 196/296/396, and

then tighten the knob.

4. To remove the GPSMAP

196/296/396, slide back the

locking lever on the the cradle,

and then unclip the unit from

the cradle.

NOTE: You may need to readjust the GPSMAP 196/296/396 position to provide the

best view of the display screen as lighting conditions change.

To secure the cable on the top of the yoke mount:

1. Remove the screws securing the cable clamp.
2. Orient the cable and secure with the clamp.

Yoke Mount Assembly

GPSMAP 196/296/396 Cradle

GPSMAP 196/296/396

Cradle

Adjustment

Knob

Locking Tab

To reconﬁgure the yoke mount for center column yokes:

1. Loosen and remove the pivot knob spacer and rubber washer.
2. Rotate the clamp assembly 90

so that the clamp opening faces away from you.

3. Secure the clamp assembly to the rest of the yoke mount using the pivot knob,

spacer, and rubber washer. Adjust the clamp angle before fully tightening the

pivot knob.

Yoke Mount in Forward-Facing Conﬁguration

Yoke Mount in Conventional Conﬁguration

Rubber Washer

Spacer

Clamp Assembly

Pivot Knob

Cable Clamp