Garmin 2006 オーナーマニュアル

G

ETTING

 S

TARTED

 > 

U

SING

 S

IMULATOR

 M

ODE

Simulator Mode is great for practicing with the unit if you are indoors and 

satellite signals are not available. When the GPSMAP 3206/3210 is in Simulator 

Mode, the GPS receiver is turned off. The unit cannot be used for actual 

navigation.

  NOTE: Do not try to navigate in Simulator Mode because the GPS receiver is 

turned off. Any satellite signal strength indicators shown are only simulations 

and do not indicate the strength of actual satellite signals.

1.  Press and hold 

ADJ/MENU to open the Main Menu.

2.  Press up or down on the 

ROCKER to highlight the System tab.

3.  Press right on the 

ROCKER to highlight the General sub tab, highlight the 

System Mode field, and press ENTER.

4.  Highlight 

Simulator, and press ENTER.

When Simulator Mode is active, the message “Simulating Operation” appears in 

the status bar at the top of each page.

  Highlight the 

Setup button, and press ENTER. The Simulator Setup 

window appears. The following options are available:
•  Current Time/Date—enter a simulated date and time.
•  Speed—enter a simulated speed. 
•   Track Control—select track control. Auto Track steers to the current 

navigation point; 

User Track allows you to enter a heading in the 

Track field. 

•  Track—enter a simulated heading.

Use the  Set Position soft key to set your location while in Simulator Mode.
You can also control the speed and track from the Compass or Highway Page. 

Press up or down on the ROCKER to increase or decrease the speed; press left or 

right to change the heading. 

1.  Press and hold 

ADJ/MENU to open the Main Menu.

2.  Press up or down on the 

ROCKER to highlight the System tab.

3.  Press right on the 

ROCKER to highlight the General sub tab, highlight the 

System Mode field, and press ENTER.

4.  Highlight 

Normal, and press ENTER.

When Normal Mode is active, the message “Normal Operation” appears in the 

status bar at the top of each page.