Garmin 2006 オーナーマニュアル

A

PPENDIX

 > 

I

NSTALLING

 

AND

 R

EMOVING

 D

ATA

 C

ARDS

The GPSMAP 2106/2110 uses optional Garmin BlueChart

®

 and MapSource

®

 data 

cards. You can use optional preprogrammed BlueChart g2

™

 data cards.

Insert data cards in the card slots located on the left side of the unit. You can 

install or remove data cards at any time, whether the unit is on or off.

1.  Open the card door by pressing the locking tab on the door toward the 

outside (left) of the unit and lifting the door open from right to left.

2.  Insert the card into the slot, with the label facing to the right and the handle 

facing toward you.

3.  Push the card into the unit. It in not necessary to force the card, and 

about 1/2" is still exposed when it is properly inserted. If the unit is on, a 

confirmation tone sounds, and a message appears on the screen noting 

the card details when the card is properly installed and accepted.

4.  Close the cover until it locks.

If you insert a data card and receive a “card format not recognized” message, 

remove the card and reinsert it. If the card is still not recognized, contact Garmin 

Product Support or your Garmin dealer for assistance. 

  NOTE: Data cards are not waterproof, should not be exposed to moisture or 

excessive static charges, and should be stored in the case supplied with the 

card.

The first time you insert a data card, the unit takes a few seconds to read the 

card. After the data card is read, a summary page appears. Press 

ENTER to 

acknowledge.

1.  Open the card door by pressing the locking tab on the door toward the 

outside (left) of the unit and lifting the door open from right to left.

2.  Grasp the card handle, and pull out firmly.
3.  If the unit is on, a confirmation tone sounds when the data card is 

removed.