Aethra d2061 ユーザーズマニュアル
ADSL TESTER D2061
USER’S MANUAL
If it is chosen: “L2: Point to Point” and / or “L3: User”, the relative
values must be programmed before in the COMMON SETUP
page
values must be programmed before in the COMMON SETUP
page
The test sequence configured can be saved with a name defined by the user, in
order to be recalled for future uses. See chapter 4 for further information.
order to be recalled for future uses. See chapter 4 for further information.
2.3.1. Setting up an automatic access test
Define the following parameters for an automatic test:
Called number: Enter the phone number of the called party.
• Remote number for calls to a remote user.
• Local number for autocalls and verification of the local access.
• Local number for autocalls and verification of the local access.
Pause between calls: enter the number of seconds for the pause between two calls.
Some exchanges require a pause ranging from 2 to 8 seconds to obtain correct
results.
Some exchanges require a pause ranging from 2 to 8 seconds to obtain correct
results.
2.3.2. Running an automatic access test
When you have defined the setup for the automatic test, continue as follows:
1
Select ‘Use this setup for testing’ in the first SETUP page.
2
Connect the instrument as displayed on the screen and
press the right cursor key.
press the right cursor key.
3
Start the automatic test. The test results appear on the
screen.
screen.
Note that:
►
The STATUS LED goes on.
►
The START key changes to STOP. Use it to stop the test.
Follows an example of “Result: Access Test” Screens:
26
CHAPTER 2 - PERFORMING AN AUTOMATIC TEST