Aethra d2001 nx ユーザーズマニュアル
USER’S MANUAL
ISDN TESTER AND ANALYZER D2001
NX
If there is an active loop, it’s not possible to change the protocol
to avoid B channel lock problems.
to avoid B channel lock problems.
In simulation mode with P-P configuration you can send the RESTART message
after selecting RESTART B-CHANNEL on the first line and then selecting the B
channel.
after selecting RESTART B-CHANNEL on the first line and then selecting the B
channel.
4
Selects RESTART B-CHANNEL. Simulation mode only.
5
Selects the B channel and sends the RESTART message.
In simulation, if the answering mode loopbox is set as Manual (see chapter 3.10), the
device shows the icon “bell” for each compatible incoming call and the user may
decide if answering or disconnecting the call manually.
device shows the icon “bell” for each compatible incoming call and the user may
decide if answering or disconnecting the call manually.
If the call is answered, the user can decide to connect the channel by making a loop
or by putting it on audio.
or by putting it on audio.
In case of 'LEASED LINE' (see chapter 3.4.4), you can manually make a loop or
connect the audio on a specific channel in any state.
connect the audio on a specific channel in any state.
If the channel is connected in audio mode, the cannel which was previously
connected goes automatically in loop.
connected goes automatically in loop.
4
To select CONNECT AUDIO / LOOP. Only in simulation
mode.
mode.
CHAPTER 6 - SMART STATUS
81