Aethra d2010 仕様ガイド
OVERVIEW
With D2010, Aethra
®
wants to satisfy all customers in deal with 2Mbit,
DATACOM interfaces and ISDN Primary Rate lines. The test set maintains
the winning characteristics of the other Aethra
®
testers that are robustness,
versatility and easiness of use.
Conceived for PRI lines installation and maintenance, D2010 is able to
perform all the most commonly used tests over WAN G.703/G.704 and VX
interfaces, by simulating indiscriminately customer premises and central
offices.
Absolutely necessary for troubleshooting is the line events monitoring
feature, such feature enables the capture of the main signalling protocols
detected over the line.
The user can carry out high impedance or “during simulation” monitoring
and, all data captured can be analyzed directly at customer premise,
through the powerful onboard decoding, or by using PC108 for Windows
TM
software which improves and makes easier the analysis thanks to smart
features very appreciated by the technicians.
The Smart Status
TM
feature provides the user all the useful information
about layer 1, 2 and 3, busy channels, V/X interface and Frame Relay
protocol. This information is always available also while a test is in progress.
FEATURES AT A GLANCE
Most performed maintenance and installation
tests over E1 interface
PCM30/PCM31 quality tester
DTE and DCE simulation
Frame Relay service control with QoS statistics
BER and IP tests over V.35, V.36, V.24, V.11/X.21
Datacom interfaces
Manual control leads management
Integrated 75/120Ω balun
Upgradeable firmware via PC
D2010
PRI DATACOM TESTER
WAN & DATACOM
V.35 & X.21 tester
V.35 & X.21 tester
2Mbit PRI ISDN
G.703, G.704 and EURO-ISDN Standard
G.703, G.704 and EURO-ISDN Standard
Easy to use test set
Fast and reliable PRI installation and troubleshooting
Fast and reliable PRI installation and troubleshooting