Pyle plcdcs300 ユーザーズマニュアル
12
Before going through the check list, check wiring connection. If any of the problems
persist after check list has been made, consult your nearest service dealer.
persist after check list has been made, consult your nearest service dealer.
Symptom
Cause
Solution
No power.
The car ignition switch is
If the power supply is properly
not on.
connected to the car accessory
circuits, but the engine is not moving,
switch the ignition key to “ACC”.
circuits, but the engine is not moving,
switch the ignition key to “ACC”.
The fuse is blown.
Replace the fuse.
Disc cannot
Presence of CD disc inside Remove the disc in the player, then
be loaded or
the player.
put a new one.
ejected.
Inserting the disc in
Insert the compact disc with the
reverse direction.
label facing upward.
Compact disc is extremely
Clean the disc or try to play a new
dirty or defective disc.
one.
Temperature inside the car
Cool off or until the ambient
is too high.
temperature return to normal.
Condensation.
Leave the player off for an hour or
so, then try again.
so, then try again.
Cassette tape
Presence of a cassette
Remove the cassette tape in the
cannot be
tape in the player.
player, then put in the new one.
loaded or
ejected.
ejected.
The temperature in the car
Cool off the inside of the car, then try
is too high.
again.
Condensation.
Leave the cassette player off for an
hour or so, then try again.
hour or so, then try again.
No sound.
Volume is in minimum.
Adjust volume to a desired level.
Wiring is not properly connected.
Check wiring connection.
Sound skips
The installation angle is
Adjust the installation angle to less
or sound
more than 30 degrees.
than 30 degrees.
quality is poor.
The disc is extremely dirty
Clean the compact disc, then try to
or defective disc.
play a new one.
The cassette is defective.
Try another cassette.
The operation
The built-in microcomputer Press the RESET button.
keys do not
is not operating properly
Front panel is not properly fixed into
work.
due to noise.
its place.
The radio does The antenna cable is not
Insert the antenna cable firmly.
not work. The
connected.
radio station
automatic
automatic
The signals are too weak.
Select a station manually.
selection does
not work.
not work.
TROUBLE SHOOTING