Viewsonic CD4620 ユーザーズマニュアル

 CD4620 

13 

 
You can attach mounting accessories to the LCD monitor in one of the following two ways: 

Lay the protective sheet on a table, which was wrapped around the monitor when it was packaged, beneath the screen 
surface so as not to scratch the screen face. 
This device cannot be used or installed without the Tabletop Stand or other mounting accessory. Failure to follow correct 
mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not 
cover damage caused by improper installation. 
Failure to follow these recommendations could result in voiding your warranty. 
Use M6 mounting screws (having a length 10 mm longer than the thickness of the mounting bracket) and tighten them 
securely. (Recommended torque: 470 - 635N•cm). ViewSonic recommends using mounting interface that comply with 
TÜV-GS and/or UL1678 standard in North America. 
 
Caution: 
For preventing the monitor from falling. 
y

  Install the monitor with metal brackets for wall or ceiling installation (commercially available) on your own responsibility. 

For detailed procedures of installation, refer to the instructions of the metal brackets. 

y

  To lessen the probability of injury and damage resulting from fall of the monitor in case of earthquake or other disaster, 

be sure to consult the bracket manufacturer for installation location. 

y

  To lessen the risk of falling of the monitor, thread commercially available rope (having a load capacity at least 1960N 

(200kgf)) through the handles at the right and left of the monitor and secure the rope to the wall mount brackets or 
ceiling mount brackets. 

y

  Do not sleep where the monitor may topple over or fall in case of an earthquake or other disaster. 

To allow heat to disperse, leave space between surrounding objects as shown in the diagram below. 

Protective Sheet

Table 

Handles 

Tabletop Stand