Viewsonic cde6501led ユーザーガイド

2

3

If the stand is provided, please read these instructions thoroughly before 
attempting this installation.
You must install your Display into the stand in order for it to stand upright on a 
cabinet or other flat surface. If you intend to mount your Display on a wall or other 
vertical surface, you must remove the stand column.
Cautions:

• Make sure that you handle your Display very carefully when attempting assembly or 

removal of the stand. If you are not sure of your ability to do this, or of your ability 

to use the tools necessary to complete this job, refer to a professional installer or 

service personnel. The manufacturer is not responsible for any damages or injuries 

that occur due to mishandling or improper assembly.

• When using a table or bench as an aid to assembly, make sure that you put down 

a soft cushion or covering to prevent accidental scratching or damage to your 

Display’s finish.

• The speaker is not intended to support the weight of your Display. Do not move or 

handle your Display by the speaker. This can cause damage to your Display that is 

not covered by the manufacturer’s warranty.

• Before attempting assembly or removal of the stand, unplug the AC power cord.

Locating grooves

Secure with 

four screws

Stand Column

Locators

Stand

Secure with 

five screws

To install the stand:
1.  Remove the stand from the box and place 

it on a table or bench.
You must pay attention to the direction 
of the stand. The wide portion of the 
stand should go towards the front of the 
Display.

2.  Lay your Display flat (screen down) on 

the edge of a table or bench. Make sure 
that you put down a soft cushion or cloth 
so that yourDisplay is not scratched.

3.  Put the stand column close to the back of the Display, align the locating grooves on 

the stand column with the Locators on the Display, and align the screw holes on 

the stand column with the holes on the Display, then secure the stand column to 

the Display with four provided screws.

4.  Align the screw holes on the stand column with the holes in the stand, then secure 

the stand to the Stand column with five provided screws.

Place the Display face-down on a cushioned surface, loosen the four screws securing 

the set to its stand column (note that only loosen a little, not detach the screws),then 

tilt the column toward lower position, then tighten these screws again.

Note:  1.  The appearance of this product in these illustrations may differ from your 

actual product,and is for comparative purposes only.

2.  We may change the design and specifications without notice.