Vidikron model 100t ユーザーズマニュアル

1.

Turn on your source components. 

2.

Turn on the main power switch on the projector.

3.

If this is an AutoScope-equipped projector, turn on the main power switch at the rear of 
the AutoScope lens motor. The lens motor power switch is located next to the AC input. 

4.

Press the ON button on the remote control – or the POWER button on the Vision 
90t/100t rear panel – to turn on the projector. The vacuum fluorescent display on the 
Vision 90t/100t rear panel briefly displays “Starting Display.” 

5.

When the projector is ready for use, the fluorescent display indicates the active source, 
signal format (NTSC or PAL), input resolution and aspect ratio; for example: 

By default, the Vision 90t/100t is configured for a “floor/front” installation, in which the 
projector is installed upright and in front of the screen. If it is installed behind the screen 
and/or mounted on a ceiling, you must change the picture orientation. To do this:

1.

Press MENU and enter the Service Menu passcode. 

2.

Select Service from the Main Menu. 

3.

Select Display Device from the Service Menu.

4.

Select Installation from the Display Device menu.

5.

Choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation method.

4

Component SD NTSC 

  480i

Anamorphic 

 

  Vidikron 90

Current Source

Format

Input

Resolution

Aspect

Ratio