VTech CS6114 ユーザーガイド

2

Install the telephone base as shown below.
Make sure that the electrical outlet is not controlled by a wall switch.
If you subscribe to digital subscriber line (DSL) high-speed Internet service 

through your telephone line, you must install a DSL filter between the 

telephone line cord and telephone wall jack. The filter prevents noise and 

caller ID problems caused by DSL interference. Contact your DSL service 

provider for more information about DSL filters.

Use only the power adapter supplied with this product. To order a 

replacement, visit our website at www.vtechphones.com or call  

 

1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call  

 

1 (800) 267-7377.

The power adapter is intended to be correctly oriented in a vertical or 

floor mount position. The prongs are not designed to hold the plug in 

place if it is plugged into a ceiling, under-the-table or cabinet outlet.

•

•

Your telephone comes ready for tabletop use. If you prefer to mount your 

telephone on the wall (optional), it is designed to mount on a standard 

telephone wall plate.
You can mount the telephone base on the wall by positioning the  

 

top hole at the back of the telephone  

 

 

 

base against the top mounting  

 

 

 

 

stud [A]. Then slide the telephone    

 

 

 

base down on the mounting  

 

 

 

 

studs [A] and [B] until it locks  

 

 

 

 

into place.

Mounting 

studs

Telephone base

[A]

[B]

Telephone base

Telephone 

line cord

Electrical outlet 

(not controlled 

by a wall switch)

Telephone 

wall jack

DSL filter (not included) is 

required if you have DSL 

high-speed Internet service 

Telephone base 

power adapter