VTech CS6228-3 ユーザーガイド

39

The handsets provided with your telephone system are pre-registered. Each 

handset is assigned a number that shows on the handset display. Additional 

handsets registered to the telephone system are assigned in sequential 

order. For instance, if the telephone system already has 

HANDSET 1 and 

HANDSET 2, the new registered handset is assigned HANDSET 3. This 

telephone system accommodates up to 12 handsets.

You can add new handsets (

CS6209, purchased separately) to your 

telephone system, but each handset must be registered with the telephone 

base before use. When first purchased, each expansion handset shows 

REGISTERED. 
To make registration easier, read all of the instructions on this page 

before you begin. If the handset screen does not show 

LOW BATTERY or 

HANDSET X, you will need to charge the handset for at least five minutes 

before registering to the telephone base.
To register a handset:

Place the unregistered handset in the telephone base or charger. If 

FIND HS 4 SEC ON BASE does not appear on the handset screen after 

a few seconds, remove the handset and place it in the telephone base or 

charger again.
On the telephone base, press and hold 

FIND HANDSET for about four 

seconds (until the red 

IN USE light on the telephone base turns on) and 

then release the button. The handset shows 

PLEASE WAIT... and it 

takes about 10 seconds to complete the registration. The handset shows 

HANDSET X REGISTERED (X represents the handset number assigned) 

and you hear a beep when the registration completes.

1.

2.

If the registration fails, the handset shows 

. To reset the 

handset, remove the handset from the telephone base and place it back in. 

Try the registration process again.
You cannot register a handset if any other system handset is in use.