Vox da10 ユーザーガイド

Setup

Please refer to the illustrations in the section entitled “The
Guitarist’s Guided Panel Tour” (page 7).

1. Turn the MASTER volume on the amp all the way

down.

2. Insert the batteries as shown on page 5.

Alternatively, plug the supplied power cord into the
power input on the rear panel, then plug the power
cord into a wall outlet.

NOTE:

Never use any Power cord other than the included one.

3. Plug your guitar into the INPUT jack on the top panel.

If you also plan to use a CD or MP3 player, or a mi-
crophone, connect the player to the AUX IN jack or
the microphone to the MIC INPUT jack on the rear
panel.

4. Turn on the STANDBY switch.
5. Slowly raise the MASTER volume to a desired level.

HINT:

The rear panel POWER SELECT switch controls the
output level of the power amp, letting you adjust the
volume while keeping that great-sounding power-amp
distortion!

HINT:

Selecting a lower output wattage during battery opera-
tion will extend battery life.

Installing Batteries

Remove the battery compartment cover located on the bot-
tom of the unit by pulling the ribbon. Insert six C alkaline
batteries as shown in the figure. Be sure to observe the cor-
rect polarity.

NOTE:

Batteries are not included. You will need to purchase
them separately. Never use any type of battery other
than alkaline batteries.

About battery life

The battery life varies depending on the output watt-
age selected by the POWER SELECT switch.

POWER SELECT

Battery life

MAX

8 hours

1.5W

18 hours

0.5W

25 hours

NOTE:

If batteries are used, the maximum output wattage of
the amplifier (i.e., with the POWER SELECT switch
set to MAX) is about 5W.