JVC GR-AX270 ユーザーズマニュアル

You can set the delay between pressing RECORDING
START/STOP and the actual start of recording. If you
secure the camcorder, you (or whomever is operating the
camcorder) can enter the scene before recording starts.

Make sure the camcorder is in the Record-Standby mode
before performing the following steps.

ACCESS MENU SCREEN

Turn the PROGRAM AE select dial to any position
except AUTO LOCK, then press MENU.

SET INTERVAL TIME

Press – or + to move the highlight bar down to
“INTERVAL TIMER”, then press FAR or NEAR to
cycle through the choices. Stop when the desired
time appears. Choose from “15S”, “30S”, “1MIN”,
“5MIN”, or select to turn the function “OFF”.

CLOSE MENU

Press MENU.

START DELAYED RECORDING

Press RECORDING START/STOP. The tally lamp
begins blinking, and the blinking frequency
increases about 5 seconds before recording is to
start. Once recording begins, the lamp stops
blinking but stays lit.

..... while the tally lamp is blinking, press RECORDING

START/STOP to stop the blinking, then set
“INTERVAL TIMER” to “OFF”.

OFF

15S

30S

1MIN

5MIN

OFF

1/4S

1/2S

1S