GE zisb480dr ユーザーズマニュアル

B

A

Water And Electrical Locations 
The opening must be prepared with the electrical
and water supply located as shown.

The cutout depth must be 24"
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.

Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot
exceed the 24" installation depth shown. The top case
trim overlaps the bottom of the soffit.

Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is

required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install 
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be 
located on rear wall as shown.

NOTE: GFI (ground fault interrupter) is not 
recommended.
• Water line can enter the opening through the floor

or back wall. The water line should be 1/4" O.D.
copper tubing or GE SmartConnect

™

kit between

the cold water line and water connection location,
long enough to extend to the front of the
refrigerator. Installation of an easily accessible 
shut off valve in the water line is required.

* Shipping height. The

refrigerator can be
adjusted to fit into a
cutout that is 83-1/2"
min. to 84-1/2" max.
height. Note that the
top case trim at the
front is 1/2" higher
and will overlap
upper cabinetry or
soffit. Use leveling
legs and wheels for a
maximum 1” height
adjustment.

Product Clearances
These refrigerators are equipped with a 2 position
door stop. The factory set 130° door swing can be
adjusted to 90° if clearance to adjacent cabinets or
walls is restricted.

*The finished cutout width must be:

35-1/2" for 36" models
41-1/2" for 42" models
47-1/2" for 48" models

90° Door Swing

130° Door Swing

*Finished Width

6"

5"

Electrical
Area

84 1/2" max

83 1/2" min

Finished
Opening

75" From Floor

to Bottom

of Electrical 

Area

24"

5"

5"

3 1/2"

Water Supply

3 1/2"

36" Models 12"
42" Models 18"
48" Models 20"

Allow minimum clearances for freezer door
(Dimension A) and fresh food door (Dimension B)
for a full 130° door swing and to allow for pan
removal.

For a 90° door swing, allow 4" min. clearance 
to a wall, for framed and stainless steel models. 
Allow 5" min. clearance for professional series models.
If the 90° door stop position is used, pan access is
maintained, but pan removal is restricted.

See illustrations pages 4 and 5 to determine 
door swing interaction with adjacent cabinets or
countertops.

C

90

° Door Swing

*Min. Distance

to Wall

Models

A

B

C

36"

13"

15"

20-5/8"

42"

13"

19"

26-5/8"

48"

15"

20"

28-5/8"

*84" From
Floor to
Top Frame

25-3/8" Framed Models
25-3/4" Stainless Steel Models

Depth Including Handles:
26-7/8" Framed Models
27-3/4" Stainless Steel Models
28-11/16" Professional Models

36", 42" or 48"

Frame to Frame

35", 41", or 47"

Case Width

*83-1/2" 

at

Rear

*4" Stainless and

Trimmed Models.

5" Pro Series