Audiovox WHS200 オーナーマニュアル

ページ / 2
I
NTRODUCTION
CONGRATULATIONS on your purchase of the
the state-of-the-art Dual Channel Stero Automotive
Infrared S t e r e o   H e a d p h o n e   S y s t e m   f r o m
Audiovox  Corporation.  This system frees you
from the tangle of headphone wires and lets you
enjoy music or video without the tangle of cables
around you.  To ensure the best performance of
your system, please read this manual carefully.
S
PECIAL
 F
EATURES
Dual Channel.
Automatic Level Control prevents input signal over
loading.
Uses high frequency infrared light to assure a clean
signal for clear reception.
E
XPLANATION
 
OF
 C
ONTROLS
 (Fig. 1)
Infrared Transmitter
1. INFRARED LED TRANSMITTERS – Sends
signals to headphones. Permits connection
to two stereo sources, providing simultaneous
transmisssion of both stereo signals.
Headphone Receivers
2. INFRARED PICKUP SENSORS – Receives
signals from transmitter.
3. BATTERY COVER
4. VOLUME CONTROL
setting to a low setting as it is possible that the
signal of one channel could be louder than the other.
1. Be sure batteries are properly installed in the
headphones.
2. Turn the headphone volume nearly off before
turning on the power.  Turn on the headphone
power then increase the headphone volume
to a comfortable level.  You can increase the
source audio volume if necessary (when
connected to a variable audio source such
as a headphone source).
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.  These limits
are designed to provide reasonable protection against
harmful interference in a residential installation.  This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
Product Specifications:
Operating range: up to 25 Ft.
Frequency Response: 35 – 18,000 Hz
S/N ratio: 60 dB
Channel Separation: 45 dB
1
Fig. 2
5. POWER SWITCH
6. POWER INDICATOR LED
7. Channel A/B Switch
8. AUTO ON/OFF MICRO SWITCH
B
ATTERY
 I
NSTALLATION
 (Fig. 2)
1. Place two alkaline AAA batteries in the
Headphones(s) battery compartment making sure
that the battery polarity is correct.
Operation
Please Read Carefully to Prevent Damage to the
Headphones or your Ears:
WARNING: Before switching between channels A
and B, remove headphones and turn the volume
Fig. 1
2
3
6
5
4
L
R
7
Auto ON/OFF
Micro Switch is
activated when
headphones are
placed on head
8