Cool-Icam cic-221 ユーザーズマニュアル

10

Please check the rubber ring before using. Check for any dirt, grains of sand, hair, dust, salt, thread scraps 

in the rubber ring and wipe off with a soft cloth or tissue paper.

• 

Apply a small drop of grease onto the rubber ring and evenly coat the entire surface of the rubber ring with the end of 

your finger.

• 

Do not use paper or cloth as fibre may stick to the rubber ring.

• 

Apply a thin and coating grease to the surface of the rubber ring, while grease can protect the rubber ring, also prevent 

water.

• 

Set the rubber ring immediately after you have applied a small drop of grease onto the rubber ring. Remember not to 

leave the greased rubber ring on a desk or other surfaces.

Place the rubber ring evenly in its groove after applying a coat of grease. Please do not pull the rubber ring, 

make sure there is no dirt on the rubber ring, and the rubber ring is not protruding, twisted.

    Please take a spare rubber ring with you. This enables you to replace when trouble occurs.

1. Place the AQ 1300 into the waterproof case as illustrated in Diagram 1.  

2. Secure lock as seen on Diagram 2.

 

 

Close the waterproof 

case completely 

Lock

Push to lock

3. To turn on the camera, press and hold the Power button until the Operation LED turns red.

4. Frame your subject using the camera viewfinder or underwater viewfinder.

5. Press the Shutter button to take a picture. Hold the camera steady. A sound is made when the picture has 

been taken.  The LCD will show a number, indicating the number of pictures can take by the camera. 

 

Shutter button

Power button/

Flash button

Underwater Viewfinder

6. Secure unlock as seen on Diagram 3. 

Unlock  the  waterproof 

case by sliding the safety 

lock switch downward.

Open Hinge lock with 

arrow direction

Open the waterproof 

case