Delfield 406-CA 仕様ガイド
Project __________________________________
Item ____________________________________
Quantity ________________________________
CSI Section 11400
Approved _______________________________
Date ____________________________________
980 S. Isabella Rd.
Mt. Pleasant, Michigan 48858
Mt. Pleasant, Michigan 48858
Phone: 800-733-8948 or 989-773-7981
Fax: 800-669-0619
Fax: 800-669-0619
www.delfield.com
Exterior bottom shall be heavy-gauge galvanized metal. Exterior ends
shall be heavy-gauge stainless steel.
shall be heavy-gauge stainless steel.
Base interior shall be one-piece thermoformed ABS plastic material,
with integral shelf supports. ABS interior is backed by a limited
lifetime warranty. Base shall be fully insulated with high-density
foamed-in-place polyurethane.
with integral shelf supports. ABS interior is backed by a limited
lifetime warranty. Base shall be fully insulated with high-density
foamed-in-place polyurethane.
Door shall have a heavy-gauge stainless steel exterior, with a
thermoformed ABS plastic interior liner, and shall be fully insulated
with foamed-in-place polyurethane. Door handle shall be black,
recessed ABS. Cabinet shall have (2) adjustable epoxy-coated wire
shelves installed.
thermoformed ABS plastic interior liner, and shall be fully insulated
with foamed-in-place polyurethane. Door handle shall be black,
recessed ABS. Cabinet shall have (2) adjustable epoxy-coated wire
shelves installed.
REFRIGERATION SYSTEM
THE FOLLOWING APPLIES TO MODELS 406/406-CA REFRIGERATORS
ONLY
Refrigeration system shall use HFC-404A refrigerant. Compressor shall
be 1/5 h.p., with condenser coil and hot gas condensate evaporator
mounted on rear of cabinet. Evaporator coil and temperature control
shall be mounted on the interior rear wall of the cabinet. Refrigerant
flow shall be controlled by a capillary tube. Cabinet shall maintain
36°F to 40°F (2°C to 4°C) interior cabinet temperature.
THE FOLLOWING APPLIES TO MODELS 406/406-CA REFRIGERATORS
ONLY
Refrigeration system shall use HFC-404A refrigerant. Compressor shall
be 1/5 h.p., with condenser coil and hot gas condensate evaporator
mounted on rear of cabinet. Evaporator coil and temperature control
shall be mounted on the interior rear wall of the cabinet. Refrigerant
flow shall be controlled by a capillary tube. Cabinet shall maintain
36°F to 40°F (2°C to 4°C) interior cabinet temperature.
THE FOLLOWING APPLIES TO MODELS 407/407-CA FREEZERS ONLY
Freezer system shall use HFC-404A refrigerant. Compressor shall be 1/4
h.p., with condenser coil and hot gas condensate evaporator mounted
on rear of cabinet. Evaporator coil and temperature control shall be
mounted on the interior rear wall of the cabinet. Refrigerant flow shall
be controlled by a capillary tube. Cabinet shall maintain -5°F to 0°F (-
21°C to -18°C) interior cabinet temperature.
Freezer system shall use HFC-404A refrigerant. Compressor shall be 1/4
h.p., with condenser coil and hot gas condensate evaporator mounted
on rear of cabinet. Evaporator coil and temperature control shall be
mounted on the interior rear wall of the cabinet. Refrigerant flow shall
be controlled by a capillary tube. Cabinet shall maintain -5°F to 0°F (-
21°C to -18°C) interior cabinet temperature.
Electrical connections shall be 115 volt, 60 Hertz, single phase. Unit
shall have a 7’ (2.1m) long electrical cord and NEMA 5-15P plug. Cord
and plug shall be located on rear of cabinet, 16” (40.6cm) above floor,
5” from the left side.
shall have a 7’ (2.1m) long electrical cord and NEMA 5-15P plug. Cord
and plug shall be located on rear of cabinet, 16” (40.6cm) above floor,
5” from the left side.
406/407
Equipment is shipped with loose 6” (15.2cm) high metal legs with black
enamel finish unless mounting is specified on original sales order.
Exterior top shall be one-piece, heavy-gauge stainless steel with front
edge turned down to form nosing and rear edge turned down.
Equipment is shipped with loose 6” (15.2cm) high metal legs with black
enamel finish unless mounting is specified on original sales order.
Exterior top shall be one-piece, heavy-gauge stainless steel with front
edge turned down to form nosing and rear edge turned down.
406-CA/407-CA
Equipment is shipped with loose 3” diameter (3.75” ride height) casters
high casters (two locking and two non-locking) unless mounting is
specified on original sales order. Exterior top shall be one-piece,
heavy-gauge aluminum wih all edges turned down.
Equipment is shipped with loose 3” diameter (3.75” ride height) casters
high casters (two locking and two non-locking) unless mounting is
specified on original sales order. Exterior top shall be one-piece,
heavy-gauge aluminum wih all edges turned down.
Specifications
Standard Features
Options &
Accessories
Accessories
•
Features Delfield’s exclusive ABS
interior. ABS is extremely durable
- it won’t dent, chip or corrode
and is backed by a limited lifetime
warranty
interior. ABS is extremely durable
- it won’t dent, chip or corrode
and is backed by a limited lifetime
warranty
•
Stainless steel front and sides
•
Two epoxy coated wire shelves,
standard installed per unit
standard installed per unit
•
Environmentally friendly R404A
refrigerant
refrigerant
•
Foamed in place polyurethane cuts
energy costs
energy costs
•
Black recessed quick grip handle
•
Rugged 6” high heavy duty metal
legs (models 406 & 407 only) Units
with a “CA” suffix are standard on 3”
diameter (3.75” ride height) casters
legs (models 406 & 407 only) Units
with a “CA” suffix are standard on 3”
diameter (3.75” ride height) casters
•
All units come standard hinged right
and may be changed at the factory
at no charge. Indicate when order is
placed
and may be changed at the factory
at no charge. Indicate when order is
placed
•
7’ cord and plug supplied
406
Undercounter refrigerator
single section on legs
406-CA Undercounter refrigerator
single section on casters
407
Undercounter freezer
single section on legs
407-CA Undercounter freezer
single section on casters
Models
406 & 407 Series
40
6 &
4
07
S
eri
es
o Stainless steel back
o Plastic laminate on front
o Additional shelf
o Stainless steel single-tier over-
o Plastic laminate on front
o Additional shelf
o Stainless steel single-tier over-
shelf
o 3” diameter (3.75” ride height)
casters
o 5” (12.7cm) diameter casters
o Model 409 stacking collar
o Model 409 stacking collar
(adds 4” to overall combined
height for use with models
406/407)
height for use with models
406/407)
o Door lock
o 220 volt, 50 Hertz electrical
o 220 volt, 50 Hertz electrical
system
Model 406-CA